- Track your orders
- Save your details for express checkout
OMAX MicroMAX Precision JetMachining Centre
OMICRO
OMAX Waterjet Range
Features
The MicroMAX JetMachining Centre is the ideal solution for ultra-precision abrasive waterjet machining. Utilising advanced high-precision optical linear encoders, innovative vibration isolation, and proven software control systems, the MicroMAX JetMachining Centre is capable of a positioning accuracy of less than five microns while retaining all the advantages of abrasive waterjet machining. The MicroMAX can machine stainless steel, titanium, carbon fibre, glass, nitinol, graphite, copper, composites, laminates, and more, with high precision and smooth finishing, for either prototyping or production. Waterjet system includes a EnduroMAX pump and software.
OMAX Benefits
- Small, efficient footprint for minimal floorspace utilisation.
- Very high precision with 0.1 micron linear optical encoder system.
- Highly rigid structure with low mass bridges and carriages.
- Stiff construction greatly reduces vibration and increases accuracy.
- Vibration isolation of table and gantries.
- All components have matched thermal expansion.
- Revolutionary patent-pending process for fine abrasive feed rate.
- Full enclosure with environmental controls provides quiet, safe and clean operation below 80dB.
- Advanced pressure controls for piercing delicate materials.
- No heat-affected zones or mechanical stresses.
- Standard OMAX 7/15 Mini MAXJET 5 Nozzle acquires finer precision cutting capability with a 0.007" orifice and a 0.015" mixing tube combination.
- Standard Rapid Water Level Control for cleaner, safer, and quieter submerged cutting completes most work below 80 dB.
- Machines a wide range of materials with high accuracy.
- Can machine hardened steel as easily as annealed steel.
- Easily cut non-conductive and reflective materials.
- Leaves behind a satin-smooth edge, reducing secondary operations.
- Shipped as a completely pre-assembled and factory-tested system.
- Designed and manufactured at the OMAX factory in Kent, Washington.
Drive Description
- Closed loop digital drives, Brushless servo motors, Intelli-TRAX drive technology with linear encoder in X-Axis, Precise motorised Z-Axis.
Additional Notes
- All products meet rigorous international standards and requirements.
- Accuracy Specifications are based on a water temperature of 22°C.
- OMAX reserves the right to adjust specifications without notice.
- Install according to local electrical code.
**Height of enclosure.
*** Additional accessories may reduce travel.
**** Recommended maximum orifice size. Smaller orifice sizes have a corresponding lower flow rate, Small, efficient footprint for minimal floorspace utilisation.
Specifications
| Machine Footprint* (L x W): | 3,100 mm x 2,1800 mm |
| Height **: | 2,134 mm |
| Weight (Tank Empty): | 1,724 kg |
| Operating Weight: | 2,404 kg |
| X-Y Cutting Envelope***: | 630 mm x 630 mm |
| Z-Axis Travel***: | 114 mm |
| Table Size (L x W): | 889 mm x 914 mm |
| Material Support Slats: | 102mm x 3mm Galvanised Steel |
| Max Supported Material Load: | 1950kg/m2 |
| Electrical Requirements: | 3 Phase 380-480 VAC +/- 10% 50-60 HZ |
| Noise Level: | Below 80 dB at one metre for submerged cutting |
| Speed: | 2,540 mm/min |
| Linear Positional Accuracy: | ±2.5 microns |
| Repeatability: | ±2.5 microns |
| Ballbar Circularity: | ±13 microns |
.jpg)
.jpg)
.jpg)
.jpg)